Construction of flexible grounding body
(1) Flexible grounding body is a kind of compound formula product.
It includes: conductive agent, preservative, blending agent,
flexibility agent, channel agent, coagulant, catalyst, etc.
(2) First dig the grounding trench, weld the horizontal grounding
body, and the vertical grounding electrode.
(3) Open the lid of the barrel and take off the two bags of raw
materials stuck to the inner lid.
(4) Open the plastic bag and turn the plastic bag over to the
outside of the barrel with a wooden stick into the barrel to stir
the sediment and liquid. (When the temperature is low, you should
use a heating rod to warm up the liquid in the barrel to about 30
degrees)
(5) Open the two external bags of raw materials and add them to the
liquid and stir well, and take them to the edge of the ditch, or
the pit, to be used.
(6) As vertical pouring can be poured directly.
(7) If you do horizontal pouring, you need to keep stirring slowly
until the resistance of the liquid in the barrel increases and
becomes sticky like porridge, then pour it into the trench to wrap
the horizontal grounding body and form a long line of pouring while
pouring.
(8) wait for its solidification to form with elastic grounding
conductor, at this time will no longer dissolve in water, can be
backfilled, the construction of flexible Hunan Hertz-Ohm
Engineering Group Co., Ltd. 4 grounding body thus ended
(9) Backfill the grounding trench, and clean up the site garbage,
measure the qualified can record the results and then leave the
site. Flexible grounding body horizontal laying diagram: Hunan
Hertz-Ohm Engineering Group Co., Ltd. 5 Scope of application Use is
not limited by environmental conditions,suitable for all areas
requiring resistance reduction.
Hunan Hertz-Ohm Engineering Group Co., Ltd. 6 Technical parameters
table Name Type Resistivity (Ω) Shock test (rate of change) Work
frequency test (rate of change) Corrosion test galvanized flat iron
Resistance reduction effect Coefficient Retardation factor Flexible
grounding body test results HD-R10Y 1.38 0.70% 2.60% 0.0022 0.16
0.833 Standard requirements HD-R10Y 5 20% 20% 0.03 0.7-0.8 0.8-0.9
